Installation Of 402617 Adjusting Gauge - Bell DATASPEED 40 Adjustments And Lubrication

SECTION 582-210-700
INSTALLATION OF 402868 ADJUSTING GAUGE FOR BACKUP BAR ADJUSTMENT (Cont)
(Forms Access Printer)
Note: For optimum print quality and maximum ribbon life the unit should be adjusted after being
at room ambient of 65
to
85 degrees Fahrenheit with all power off for at least three hours.
• Remove old ribbon.
• Remove tear bar assembly.
• Remove type carrier.
• Install nevI ribbon and insert
single-ply paper.
• Insert 402868 gauge on type
carrier track against backup bar.
40P253 Forms Access Printer
INSTALLATION OF 402617 ADJUSTING GAUGE (Forms Access Printer)
Note:
If using early design 402617 gauge (with spacers assembled on the posts) the spacers must be
removed.
• With ac power off, remove paper and ribbon.
• Remove tear bar assembly.
• Remove type carrier.
Insert 402617 gauge on type carrier track with front edge
against backup bar. Position gauge so protrusions at rear
line up with no. 1 and no. 80 print hammers.
(Left Top View)
Page 24
GAUGE
LOCATION
(Right Top View)