Table of Contents
Advertisement
BACKUP BAR (Final-- Under Power) (Cont)
To Check
ISS 3, SECTION 582-210-700
Install the type carrier. Insert a single sheet of paper and with a random test, check the copy density for
conformance to the requirement.
On units equipped with early design print hammer bumper (black),
if
printed copy is not satisfactory, re-
peat the adjustment using three
(3)
thicknesses of paper and recheck copy for density with the type
carrier and a single sheet of paper installed.
If
further density is required (in isolated cases), the printer
may be adjusted using two (2) or one (1) thickness of paper.
Note
1:
Each time the BACKUP BAR (final) adjustment is made, the following adjustments must also
be made:
LEFT AND RIGHT CARRIER SPROCKETS
RIBBON GUIDES (Final) (See Note
2.)
Note
2:
On the forms access printer, the ribbon guide adjustment need not
be
remade unless the carrier
track channel has been replaced or disassembled.
Page 31
Advertisement
Table of Contents
