Form-Out Contact To Belt Spacing (Final) - Bell DATASPEED 40 Adjustments And Lubrication

SECTION 582-210-700
FORM-OUT CONTACT TO BELT SPACING (Final) (Tractor Feed and Forms Access Printers)
Requirement (A)
The contact shall have started to rise off the surface of the belt by
Min some --- Max 0.006 inch
when contacting the full width cam lobe.
Take Up Play
This Direction---------,
IDLER
PULLEY
REAR PROJECTION
To Check
Take Up Play
This Direction-----,
• Latch the line feed clutch.
• Position form selector lever in. the fourth detent position.
• Move line feed pawls out of engagement with line feed gear.
Tractor Feed
LINE FEED GEAR
Forms Access
• Rotate paper advance knob until the slope part of the contact just touches the long cam.
• Reengage line feed pawls. (See examples below.)
• Reengage paper advance knob.
Examples
Page 48
li";":JOhin'
Feed Pawls
(Properly Engaged)
Feed Pawls on top
of Line Feed Gear
(Not Engaged)
Feed Pawls
(Advanced)