Top Cover (Preliminary) - Bell DATASPEED 40 Adjustments And Lubrication

SECTION 582-210-700
TOP:COVER
MOUNTING seRE"
Note: Tear bar adjusting screws
should not be disturbed. See
TEAR BAR AND TOP COVER
(Final) adjustment.
TOP COVER (Preliminary)
(Forms Access Printer)
Requirement
~
(A)
(B)
The gap requirement between the top cover and tear bar is determined
by
the thickness of the forms
stock used, as follows:
(A) If form thickness is 0.005 inch to 0.010 inch, gap should be
Min 0.020 inch --- Max 0.030 inch
(B)
If
form thickness is 0.010 inch to 0.018 inch, gap should be
Min 0.025 inch --- Max 0.040 inch
(C) If form thickness is 0.018 inch to 0.025 inch, gap should be
Min 0.030 inch --- Max 0.050 inch
To Adjust
With the top co~ermounting screws (4) friction tight, position the top cover to meet reqllired gap' (per
form thickness used) when measured near. ends of tear bar. Tighten the top cover mounting screws
and recheck gap.
Note 1:
Printer is factory adjusted to meet Requirement (A).
Nbte2: .
If the printer is utilized in
a
ribbonless application, this adjustment is considered final.