Form-Out Contact To Belt Spacing (Preliminary) - Bell DATASPEED 40 Adjustments And Lubrication

ISS 3, SECTION 582-210-700
FORM-OUT CONTACT TO BELT SPACING (Preliminary) (Tractor Feed and Forms Access Printers)
Requirement
The high side of the eccentric bushing shall be positioned approximately 90 degrees to the form-out
contact arm as shown.
To Adjust
Loosen the eccentric bushing clamp screw and position the eccentric to meet requirement.
FORM SELECTOR
LEVER
CLAMP SCREW
ECCENTRIC POST--_ _ _ _ _
U:.
(Clamp Nut On
"-==-::J~"P
Opposite Side)
CLAMP NUT
(Left View)
Requirement
ECCENTRIC POST
(Clamp Nut on
Opposite Side)
Tractor Feed
ECCENTRIC
BUSHING
Forms Access
FORM·OUT
CONTACT
JUST TOUCHING
With the form selector lever seated in the No.4 position detent groove, the form-out contact shall
be just touching the form-out belt.
To Adjust
Loosen the eccentric post clamp nut friction tight and position the eccentric post to meet requirement.
Note: Keep eccentric post toward right side of slot.
Page 47