Table of Contents
Advertisement
SECTiON 582:210-700
TRACTOR PHASING (Tractor Feed and Forms Access Printers)
Requirement
The phasing marks on the right and left trac-
tors should be in line with each other.
To Adjust
Remove left tractor from splined shaft, turn
tractor, and reassemble on splined shaft with
its phasing mark at the same spline shaft
groove as phasing mark of other tractor.
Note:
Factory adjusted; should not normally
require adjustment unless tractors are removed
or replaced.
Tractor Feed Printer
TRACTOR LID (Tractor Feed Printers)
Requirement
PHASING
MARK
Forms Access Printer
TRACTOR
SIDE PLATE
The upper paper guide should contact the side plate of both rightand left tractors.
To Adjust
Loosen tractor side plate upper mounting screws friction tight. Position left-hand tractor side plate
approximately in the center of its adjustment range and tighten its mounting screws. Position right-hand
tractor side plate to meet requirement. Tighten right-hand tractor mounting screw.
Page 52
FEED
BELT
/ - OIRECTION
OF DRIVE
SIDE PLATE
>;0--,;---
SPLINE DRIVE
Advertisement
Table of Contents
