Form-Out Belt Idler Arm - Bell DATASPEED 40 Adjustments And Lubrication

SECTION 582-210-700
IDLER
ARM ASSEMBLY
FORM-OUT BELT IDLER ARM (Tractor Feed and Forms Access Printers)
-Position form-out belt against respective sprocket flanges.
Requirement (A)
FORM-OUT
BELT
The centerline of the idler arm assembly should be position'ed approximately 90 degrees to th,! flat
(straight portion between sprockets) of the belt.
Requirement
(B)
There should be a minimum of 1/32 inch between the right edge of the idler arm assembly and the
forilled tab on the pivot nUt plate.
To Adjust
Loosen idler arm adjustment knob friction tight. With belt engaged in both sprockets and against the
flanges of each sprocket, move the adjusting nut along elongated slot until requirements ate met.
Tighten knob.
Note: . With the 402850white belt it may notbe ilOssible to meetrequirelllent
(A)
because oflength 6f
slot. The requirement will be considered met when the nut has been positioned against the left end of slot.
Page 44