Driving Off, Shifting And Driving; Driving Off; Parking; Driving On A Slope - Zetor PRIMO HT 20 NC Operator's Manual

Driving Off, Shifting and Driving

Driving Off

1. Lift the implement.
2. Place the main shift lever, range shift lever and direction shift lever in the required position.
3. Release the parking brake by depressing the brake pedal.
Warning:
The reverse speed is almost the same as the forward speed. Check the surrounding area

carefully before reversing.
Never reverse with the shift lever in the H position. Driving speed is high and an accident

could occur.

Parking

1. Use the manual throttle lever to set the engine
speed low.
2. Slowly release the forward pedal (HST type) and
the accelerator pedal (mechanical). Press the brake
pedals to brake.
3. When the vehicle is completely stationary, move
the shift lever to the neutral position.
4. Apply the parking brake.
5. If an implement is attached to the vehicle, lower it.
6. After parking the vehicle, remove the key from the
switch.
For parking brake operation, see Parking brake pedal chapter.
Warning:
After parking, do not forget to apply the parking brake.

If possible, do not park on a slope. If parking on a slope is absolutely necessary, secure the

rear wheels with wedges.

Driving on a Slope

Driving Off on a Steep Slope

1. Press the brake pedals.
2. Place the shift lever to the low speed position.
3. Use the manual throttle lever to set the engine speed to a medium value.
4. At the same time, release the parking brake pedal.
OPERATION
PRIMOHT20NC_0083
87