Tips For Driving On A Slope; Precautions When Entering / Exiting A Field; Loading On Truck / Unloading - Zetor PRIMO HT 20 NC Operator's Manual

Tips for Driving on a Slope

1. Place the main shift lever in a low-speed position on the slope to avoid stopping the engine.
2. Keep the speed low when driving downhill.
NOTE
If the needle on the coolant temperature gauge points to ''H'', the engine has overheated. If you

continue to drive in this situation, serious damage to the engine components may occur. Take
appropriate action immediately.

Precautions when Entering / Exiting a Field

1. Check that the left and right brake pedals are connected.
2. If there is a deep edge in the field, it is dangerous to enter/exit it.
Use ramps.
3. Move perpendicularly to the edge.
4. When leaving the field, lower the implement so that the front wheels cannot be lifted.
5. To use full power, it is recommended to reverse into the field.
Warning:
When working on a slope, make sure to maintain the stability of the tractor. It may be lost and

the machine may roll over.
It is very dangerous to carry a person as a counter-weight on the front part of the tractor.

For detailed information on measures, see Safety Instructions for Users chapter.

Loading on Truck / Unloading

1. Reverse when loading the tractor on the truck.
2. Extreme care must be taken when using the ramp.
3. If the engine stops on the ramp, immediately depress the brake pedals and slowly release them to
drive the tractor on the ground. Then start the engine again and drive on the ramp.
88
OPERATION