WAGO-I/O-SYSTEM 750
750-461 2AI Pt100/RTD
1
Notes about this Documentation
Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation is
included, if necessary.
1.1
Validity of this Documentation
This documentation is only applicable to the I/O module 750-461
(2AI Pt100/RTD) and the variants listed in the table below.
Table 1: Variants
Item number/Variant
Pt-resistance sensors
750-461
750-461/000-003
750-461/000-006
750-461/000-200
750-461/025-000
Ni-resistance sensors
750-461/000-004
750-461/000-005
750-461/000-009
resistance measuring
750-461/000-002
750-461/000-007
Operating mode configurable with WAGO-I/O-CHECK
or PROFIBUS DP and PROFINET device description (GSD file)
750-461/003-000
NTC- resistance sensors
750-461/020-000
Documentation Validity for Variants
Unless otherwise indicated, the information given in this documentation applies to
listed variants.
Manual
Version 1.4.0
Notes about this Documentation
Designation
2AI Pt100/RTD
2AI Pt1000/RTD
2AI Pt100/RTD/optimized temperature drift
*)
2AI Pt100/RTD S5
*)
Adapted data format for S5-controller with functions block 250
2AI Pt100/RTD/T
2AI Ni100/RTD
2AI Ni1000 TK6180/ RTD
2AI Ni1000 TK5000/ RTD
2AI resistance measuring 10R-1k2
2AI resistance measuring 10R-5k0
2AI Pt100/free configurable
2AI NTC 20k
5