Epygi Manual III User Manual page 8

This will generate a special user's failure log with the details of the last call for administrator's revision. Use this code in the cases your
Logs Collecting
administrator has advised you. You will get the dial tone after this feature code is dialed.
Used by ACD agent to easy login or logout to all groups where it is subscribed to.
Easy Login/Logout
No Answer Call Forwarding Management
the Caller ID Based Services
entering the *84 menu. If no
forwarding service and a voice message will ask to configure the forwarding settings first. (See further key codes below.)
Access to the Shared Mailboxes used to access other extension's mailboxes on the QX IP PBX. If the mailbox is configured as shared, no
password will be prompted to enter it. Otherwise, the corresponding extension's password will be prompted to enter its mailbox. The
mailbox can be configured as shared either by administrator from Extension's Management - Voice Mailbox Settings page (see
Manual II: Administrator's Guide) or by the extension's user from
mailbox, you will get all the same menu options and functionality as you have in your own mailbox.
Listen in to the third party's call. You will not be able to speak in the call.
Whisper to the third party's call. You will be able to listen to the call and speak only to extension you have dialed.
Barge in to the third party's call. You will be able to listen to the call and speak to all participants.
If you have problems using
This feature code is only available when the extension you dial is in the call.
Intercept allows you to pick up a ringing call on another specified extension after this feature code is dialed.
PBX services accessible during the call (for phones connected to the FXS lines), characterized by starting with the key
is used to hold the active connection, in order to place or receive a second call. When holding the first call, the user is able to
Keeping a call on hold
place a call to a third party, in particular cases for conferencing (3 way calling) or call transferring purposes. To be able to receive a

second call while currently being on a call, the call waiting service should be enabled on the
a second call comes in, the beep sound indication is heard in the active call.
Press to hold a call partner and to get a dial tone (within approximately 1 second). Enter the
Transferring a call without consultation
where the call should be transferred to. Hang up on the ring tones. The call on hold will be transferred to the specified
destination.
phone
Press to hold a call and to get the dial tone (within approximately 1 second). Enter the
Transferring a call with consultation
where the call should be transferred to. Talk to the called party and then hang up. The call partner on hold will be connected to
the called party.
phone
Joining active lines to start a conference call
Hold the first call (
conference call. To terminate the conference call with the first or second party, use correspondingly

combinations.
Pressing
initiating the a conference call.
Attention:
After initiating a conference call, the extension can leave the conference by pressing
between the other two parties.
Attention:
QX50/QX200/QX2000; (SW Version 6.0.x)
configured according to the No Answer Call Forwarding settings for Any Address entries in
table will get activated. To toggle (activate or deactivate) the forwarding service again, press 1 directly after
No Answer Call Forwarding is configured for Any Address entries, the system will not activate the
, and
  
), make the second call (or receive a new one) and press
and waiting for 5 seconds will initiate a call switch and will connect you back to the held party instead of
Many Extensions Ringing page. Once entered the other extension's
feature codes, turn to your system administrator for the corresponding configuration.
Basic Services – General Settings
to join both active lines together for the

QX50/QX200/QX2000 Manual III: Extension User's Guide
:
page. When
phone number of the destination
phone number of the destination
or
 
without terminating the call





 +
Extension
Number +

+
Extension

Number +

+
Extension

Number+

+
Extension

Number+


key

8