Call Codes Available In Auto Attendant - Epygi Manual III User Manual

Call Codes Available in Auto Attendant

The following key combinations are available to access and manipulate within Auto Attendant services for external calls addressed to the Auto Attendant,
incoming calls from the mainline routed to the Auto Attendant or local calls made by dialing the 2-digit attendant extension:
(press on the Auto Attendant welcome message to dial the ZeroOut destination)
Incoming call to Auto Attendant Services

Extensions Menu - establishing a connection to an extension on the called QX IP PBX
Remote Enquiry - establishing a connection to the mailbox of an extension on the called QX IP PBX
Call Relay Menu - mainly for external calls (IP/PSTN) but local calls are also allowed.
This service avoids having to hang up and redo the entire dialing process if QX IP PBX detects an error in the dialed number
or the user decides to cancel the call and dial a new number. By entering the combination
and the user will get an invitation to dial a new one. This is applicable during dialing, after the ring tone has started, and after
the call has been established.
" " digit combination is
During the dialing,
applicable:
After ring tones start,
•
After call establishment.
•
•
Remote Configuration Menu – allows remote enabling/disabling of the Unconditional Call Forwarding service for Any
Address or Other Addresses entries in the
forwarding destination.
Non-Permanent Call Back – allows PSTN callers registered in the Authorized Phones Database to change the callback
destination for a one-time callback. After the caller hangs up, QX IP PBX will call back to the newly specified number. This
change will not be logged into Authorized Phones Database.
Permanent Call Back – allows PSTN callers registered in the Authorized Phones Database to reconfigure Authorized
Phones Database entries by modifying the caller's and/or callback numbers. The caller will then be able to initiate a callback
only by calling from the newly specified caller number.
Allows to modify Auto Attendant greeting and menu messages, as well as to manage universal extension messages.
Administrator Login
Call Routing Management Menu – allows managing the routing entries in the Call Routing table, i.e. to enable/disable
certain routing rules by dialing key combinations pre-configured on each routing entry.
Extensions Directory - accesses QX IP PBX extensions by spelling the extension's user name using the keypad on the
phone.
Quits the Auto Attendant and starts a dial tone.
QX50/QX200/QX2000; (SW Version 6.0.x)
This feature can only be used when accessing from PSTN to the external SIP
Under the following restrictions:
destination through QX IP PBX's AA or vice versa.
•
This feature is not available on the second QX IP PBX Auto Attendant (calling from
one Auto Attendant to another).
•
Caller ID Based Services
QX50/QX200/QX2000 Manual III: Extension User's Guide
the call will be interrupted
table on the extension and to modify the certain
Keys
-
(already in)









16