Add Info [Erroraddinfo] For Dr03 - Siemens SIMATIC ET 200SP Operating Instructions Manual

Data and command errors
7063 Parameter error DR 24 7063
7064 Parameter error DR 25 7064
7067 Parameter error DR 28 7067
7072 Parameter error DR 45 7072
9.4.4

Add info [errorAddInfo] for DR03

Additional information is available for most data/command errors. The cause of the error is
described in detail with this information. If a data/command error bit is set, the additional
information is also filled accordingly. Thus, the error bits and the additional information must be
evaluated together in the program to identify the exact cause of the error.
If additional information not listed above appears for a data/operating error bit, it is a parameter
ID. This defines the exact parameter that caused the error.
The following table presents the association between the parameter and parameter ID.
Table 9-3
Parameter
Scale name header
Scale name
Weight unit
Restriction code
Number of weighing ranges
Minimum weight weighing range 1
Maximum weight weighing range 1
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA
Error code Add info
[errorCode] [errorAd‐
dInfo]
9192
9183
9182
Parame‐
ter ID
Parame‐
ter ID
9507
Parame‐
ter ID
7068
Parame‐
ter ID
7075
Add info [errorAddInfo] for DR03
Description
Coarse dribbling is not plausible
Filter depth material flow is too high
Minimum material flow is negative
Additional information indicates an implausible parameter in DR 24
Parameter ID of the affected parameter in DR 24
Additional information indicates an implausible parameter in DR 25
Parameter ID of the affected parameter in DR 25
Dosing active
Additional information indicates an implausible parameter in DR 28
Parameter ID of the affected parameter in DR 28
Additional information indicates an implausible parameter in DR29
Additional information indicates an implausible parameter in DR 45
Parameter ID of the affected parameter in DR 45
Additional information indicates an implausible parameter in DR10
Interrupts/diagnostic messages
9.4 Operating errors
Add info [errorAddInfo]
301
302
303
304
305
306
307
137