Capture Of Weighings Into Statistics [Statisticsdata]; Dr23 Material Parameters; Parameter Relation [Parameterrelation]; Fine Weight [Fineweight] - Siemens SIMATIC ET 200SP Operating Instructions Manual

6.17.11

Capture of weighings into statistics [statisticsData]

Defines, based on the tolerance evaluation, which dosing results are to be included in the
statistics calculation.
Selection code
0 (default)
1
2
6.18

DR23 Material parameters

6.18.1

Parameter relation [parameterRelation]

The parameter defines how the specifications for the fine weight and trailing weight are to be
interpreted. The following options are available for selection:
Selection
code
0 (default)
1
6.18.2

Fine weight [fineWeight]

Defines how much material is to be dosed only in the fine dosing phase. Depending on the
selected unit reference (DR23), the value must be interpreted as a percentage of the set point
(DR20) or as an absolute weight value.
Example:
Set point (DR20) = 100 kg
Selection code for parameter relation (DR 23) = 0
Fine value (DR 23) = 20
→ As a result of this setting, 20 kg (20% of 100 kg) is dosed with fine flow only.
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA
Meaning
All dosings (with tolerance check) are included following "Dosing completed" in the
calculated statistics.
Dosings (with tolerance check) of "GOOD" class are included following "Dosing com‐
pleted" in the calculated statistics.
Dosings (with tolerance check) of "BAD" class are not included following "Dosing
completed" in the calculated statistics.
Meaning
Fine and trailing weights are interpreted as specified percentages of the set point (DS
20).
Fine and trailing weights are interpreted as absolute weights in the weight unit.
Parameter assignment/addressing
6.18 DR23 Material parameters
91