Siemens SIMATIC ET 200SP Operating Instructions Manual page 135

Data and command errors
7050 Unknown data record
7051 Parameter input not
possible now
7052 Parameter is write pro‐
tected and cannot be
changed
7053 Error in calibration pa‐
rameter DR03
7054 Parameter error DR05 7054
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA
Error code Add info
[errorCode] [errorAd‐
dInfo]
9500
9501
9502
9511
9532
9533
9550
9551
9552
9553
9554
7050 -
7051
9507
9510
9511
7052
Parame‐
ter ID
7053
Parame‐
ter ID
9510
9520
9521
9524
9525
9526
9610
9611
9613
9614
Parame‐
ter ID
Description
Fault present
No stability
Waiting for stability
Write protection enabled
Current weight is out of defined weighing range
Total too small
Trace memory full
Protocol memory full
Logging task is busy
Weight did not change since last logging
Logbook contains no entries
Requested data record is unknown.
A parameter input is currently not possible. Additional information
contains details.
Dosing active
Service mode is not active
Write protection enabled
A parameter input is currently not possible due to active write pro‐
tection. Additional information contains details about the parameter
involved.
Parameter ID of the parameter involved
Additional information indicates an implausible parameter in DR 3
Parameter ID of the affected parameter in DR 3
Service mode is not active
Increment between calibration digits too small
Sequence of calibration points is not correct
Calibration weight is 0
Falling characteristic curve not allowed by OIML
Alternating calibration characteristic curve is not allowed
Weighing range max - min error
Resolution not permitted
OIML and 6000d provision violated
Zeroing or zero setting limits are not OIML-compliant
Additional information indicates an implausible parameter in DR05
Parameter ID of the affected parameter in DR05
Interrupts/diagnostic messages
9.4 Operating errors
135