Indications; Indications During Commissioning; Indications In The Display - AUMA SA 25.1 Operating Instructions Manual

Indications

7. Indications
7.1.

Indications during commissioning

LED test
Language selection
Startup menu
7.2.

Indications in the display

Status bar
52
SA 25.1 SA 48.1/SAR 25.1
When switching on the power supply, all LEDs on the local controls illuminate for
approx. 1 second. This optical feedback indicates that the voltage supply is connected
to the controls and all LEDs are operable.
Figure 56: LED test
During the self-test, the language selection can be activated so that the selected
language is immediately indicated in the display. For this, set selector switch to
position 0 (OFF).
Activate language selection:
1. Display indicates in the bottom row: Language selection menu? 'Reset'
2. Press push button RESET and hold it down until the following text is displayed
in the bottom line: Language menu loading, please wait.
Figure 57: Self-test
The language selection menu follows the startup menu.
The current firmware version is displayed during the startup procedure:
Figure 58: Startup menu with firmware version: 04.00.00 xxxx
If the language selection feature has been activated during the self-test, the menu
for selecting the display language will now be indicated. For further information on
language setting, please refer to chapter <Language in the display>.
Figure 59: Language selection
If no entry is made over a longer period of time (approx. 1 minute), the display
automatically returns to the first status indication.
The status bar (first row in the display) indicates the operation mode [1], the presence
of an error [2] and the ID number [3] of the current display indication.
SAR 30.1 Control unit: electronic (MWG)
AC 01.2 Non-Intrusive Modbus RTU