Output Drive Types B And E; Multi-Turn Actuator With Output Drive Types B: Mount To Valve/Gearbox - AUMA SA 25.1 Operating Instructions Manual

SA 25.1 SA 48.1/SAR 25.1
AC 01.2 Non-Intrusive Modbus RTU
4.3.2.

Output drive types B and E

Application
Design
Information

4.3.2.1. Multi-turn actuator with output drive types B: mount to valve/gearbox

SAR 30.1 Control unit: electronic (MWG)
For rotating, non-rising valve stem
Not capable of withstanding thrust
For output drive types B/B1/B2, the connection to the valve or the gearbox is made
by directly placing the multi-turn actuator hollow shaft onto the input shaft of the valve
or gearbox.
For output drive types B3/B4/E, the connection is made via output drive sleeve which
is inserted into the bore of the hollow shaft of the multi-turn actuator and fixed by a
retaining ring.
When exchanging the output drive sleeve, later retrofitting to a different output drive
type is possible
Figure 16: Output drive type B
[1] Multi-turn actuator flange
[2] For output drive types B/B1/B2 hollow shaft with keyway
[2]* For output drive types B3/B4/E, an output drive sleeve is fitted into the hollow
shaft
[3] Gearbox/valve shaft with parallel key
Spigot at valve flanges should be loose fit.
Figure 17: Mounting output drive types B
[1] Multi-turn actuator
[2] Valve/gearbox
[3] Valve/gearbox shaft
1. Check if mounting flanges fit together.
Assembly
19