AUMA SA 25.1 Operating Instructions Manual page 4

Table of contents
8.2. Analogue signals (analogue outputs)
9. Commissioning (basic settings)...........................................................................................
9.1. Type of seating: set
9.2. Torque switching: set
9.3. Limit switching: set
9.4. Fieldbus address (slave address), baud rate, parity and monitoring time: set
9.5. Test run
9.5.1. Direction of rotation at mechanical position indicator: check
9.5.2. Direction of rotation at hollow shaft/stem: check
9.5.3. Limit switching: check
10. Commissioning (settings/options in the actuator).............................................................
10.1. Switch compartment: open/close
10.2. Mechanical position indicator (self-adjusting)
10.2.1. Mechanical position indicator: set
10.2.2. Gear stage of the reduction gearing: test/set
10.3. Mechanical position indication via indicator mark (not self-adjusting)
10.3.1. Mechanical position indicator: set
10.3.2. Gear stage of the reduction gearing: test/set
11. Corrective action....................................................................................................................
11.1. Faults during commissioning
11.2. Fault indications and warning indications
11.3. Fuses
11.3.1. Fuses within the actuator controls
11.3.2. Fuse replacement
11.3.2.1. Replace fuses F1/F2.
11.3.2.2. Test/replace fuses F3/F4
11.3.3. Motor protection (thermal monitoring)
12. Servicing and maintenance...................................................................................................
12.1. Preventive measures for servicing and safe operation
12.2. Maintenance
12.3. Disposal and recycling
13. Technical data.........................................................................................................................
13.1. Technical data Multi-turn actuators
13.2. Technical data Actuator controls
14. Spare parts.............................................................................................................................
14.1. Multi-turn actuators SA 25.1
14.2. AC 01.2 actuator controls with SD electrical connection
14.3. Wall bracket
15. Certificates..............................................................................................................................
15.1. EU Declaration of Incorporation / Declaration of Conformity
Index........................................................................................................................................
Addresses...............................................................................................................................
4
SA 25.1 SA 48.1/SAR 25.1
SA 48.1/SAR 25.1
SAR 30.1 Control unit: electronic (MWG)
AC 01.2 Non-Intrusive Modbus RTU
SAR 30.1
60
61
61
62
63
65
66
66
67
68
69
69
70
70
71
72
72
73
75
75
75
79
79
80
80
80
81
82
82
83
83
84
84
86
92
92
94
96
98
98
99
102