Assembly; Mounting Position; Handwheel Fitting - AUMA SA 25.1 Operating Instructions Manual

SA 25.1 SA 48.1/SAR 25.1
AC 01.2 Non-Intrusive Modbus RTU
4.

Assembly

4.1.

Mounting position

4.2.

Handwheel fitting

Information
SAR 30.1 Control unit: electronic (MWG)
The product described in this document can be operated without restriction in any
mounting position.
For transport reason, handwheels with a diameter of 400 mm and larger are supplied
separately within the scope of delivery.
Damage at the change-over mechanism due to incorrect assembly!
Only pivot change-over lever manually.
Do NOT use extensions as lever for operation.
First engage manual operation correctly, then mount handwheel.
1. Manually lift the red change-over lever while slightly turning the shaft back and
forth until manual operation engages.
Manual operation is properly engaged if the change-over lever can be shifted
by approx. 85°.
Figure 10:
2. Push handwheel over the red change-over lever then onto the shaft.
Figure 11:
3. Release change-over lever (should snap back into initial position by spring ac-
tion, if necessary, push it back manually).
Assembly
15