AUMA SA 25.1 Operating Instructions Manual page 74

Commissioning (settings/options in the actuator)
74
SA 25.1 SA 48.1/SAR 25.1
3. Loosen screw [1].
4. Set crown wheel [2] to desired level according to table.
5. Tighten screw [1].
6. Place indicator disc on shaft.
7. Set mechanical position indicator.
Figure 90: Control unit with reduction gearing
[1] Screw
[2] Crown wheel
SAR 30.1 Control unit: electronic (MWG)
AC 01.2 Non-Intrusive Modbus RTU