AUMA SA 25.1 Operating Instructions Manual page 91

SA 25.1 SA 48.1/SAR 25.1
AC 01.2 Non-Intrusive Modbus RTU
Service conditions
Enclosure protection according to
EN 60529
Pollution degree according to IEC
60664-1
Vibration resistance according to
IEC 60068-2-6
Corrosion protection
Coating
Colour
Accessories
Wall bracket
Programming software
Torque measurement flange DMF
Further information
Weight
EU Directives
SAR 30.1 Control unit: electronic (MWG)
Standard: IP68
Option: Terminal compartment additionally sealed against interior of actuator controls (double
sealed)
According to AUMA definition, enclosure protection IP68 meets the following requirements:
Depth of water: Maximum 8 m head of water
Duration of continuous immersion in water: Maximum 96 hours
Up to 10 operations during continuous immersion
Modulating duty is not possible during continuous immersion.
For exact version, refer to actuator controls name plate.
Pollution degree 4 (when closed), pollution degree 2 (internal)
1 g, from 10 Hz to 200 Hz
Resistant to vibration during start-up or for failures of the plant. However, a fatigue strength may not be
derived from this. (Not valid in combination with gearboxes)
Standard: KS: Suitable for use in areas with high salinity, almost permanent condensation, and high
pollution.
Option: KX: Suitable for use in areas with extremely high salinity, permanent condensation, and
high pollution.
Double layer powder coating
Two-component iron-mica combination
Standard: AUMA silver-grey (similar to RAL 7037)
Option: Available colours on request
For actuator controls mounted separately from the actuator, including plug/socket connector.
Connecting cable on request.
Recommended for high ambient temperatures, difficult access, or in case of heavy vibration during
service.
Cable length between actuator and actuator controls is max. 100 m (not suitable for version with poten-
tiometer in the actuator). Instead of the potentiometer, an MWG has to be used. (MWG requires separate
data cable.)
AUMA CDT (Commissioning and Diagnostic Tool for Windows-based PC)
AUMA Assistant App (Commissioning and Diagnostic Tool for Android devices)
Accessory for torque measurement for SA/SAR 07.2
Approx. 7 kg (with AUMA plug/socket connector)
Electromagnetic Compatibility (EMC): (2014/30/EU)
Low Voltage Directive: (2014/35/EU)
Machinery Directive: (2006/42/EC)
Technical data
SA/SAR 16.2
91