Seat ALHAMBRA Owner's Manual page 65

Note
Different versions of the instrument panel are available and therefore the
versions and instructions on the display may vary. In the case of displays
without warning or information texts, faults are indicated exclusively by the
warning lamps.
When several warnings are active at the same time, the symbols are
shown successively for a few seconds. The symbols will stay on until the fault
is rectified.
Compass*
Fig. 36 Magnetic zones.
The compass does not require calibration in vehicles for which the navigation
system was mounted at the factory. The option compass disappears.
Safety First Operating instructions
The compass in vehicles in which the navigation system was not mounted at
the factory, is permanently and automatically calibrated. If electronic or metal
accessories (mobile phone, television) are subsequently mounted in the
vehicle, the compass should be recalibrated manually.
Adjusting the magnetic zone
Switch the ignition on.
Select the Settings menu followed by the option Compass and Zone.
Select the magnetic zone corresponding to the position of the vehicle
page 63, fig. 36.
Adjust and confirm the magnetic zone (1-15).
Calibrating compass
To calibrate the compass you must be in one of the valid magnetic zones with
sufficient space to be able to trace a circumference with the vehicle.
Switch the ignition on.
Select the Settings menu followed by the option Compass and Calibrate.
Confirm the message Describe a complete circumference to calibrate the
compass with OK and then trace a complete circumference driving at approx-
imately 10 km/h (6 mph).
When the corresponding cardinal point is displayed, the calibration is
complete.
Service interval display
The inspection display appears on the instrument panel
A
.
4
SEAT differentiates between services with engine oil change (Maintenance
Service) and services without engine oil change (Inspection Service). The
service interval display only gives information for service dates which involve
Practical tips
Cockpit
page 60, fig. 35
Technical Data
63