Seat ALHAMBRA Owner's Manual page 241

WARNING (continued)
Adjust your speed and driving style to visibility, road, traffic and
weather conditions.
If the road surface is slippery, take care when accelerating.
When a system is operating, lift your foot off the accelerator.
WARNING
It is possible that the combination stabilisation system does not correctly
recognise all driving situations.
It is possible that the stabilisation system does not detect snaking of a
light trailer and thus does not intervene.
When driving on slippery ground, the trailer could jack-knife despite
the stabilisation system.
Trailers with a high centre of gravity may even tip over before they start
to rock sideways.
If a trailer is not used and the trailer socket is connected (for example,
installation of a bicycle carrier with lights), repeated automatic braking
may occur in extreme driving conditions.
Safety First Operating instructions
Retrofitting a tow hitch
Fig. 154 Measurements and attachments to retrofit a tow hitch.
SEAT recommends visiting a specialist workshop to retrofit a tow hitch. For
example, it may be necessary to adjust the cooling system or to include
thermal plates. SEAT recommends visiting a qualified workshop.
In any case, the separation distances must be observed when fitting a tow
hitch. The distance between the centre of the tow hitch ball and the road
A
surface fig. 154 must never be lower than that indicated. This also
D
applies when the vehicle is fully laden, including maximum drawbar load.
Separation distances fig. 154:
A
Attachment points.
A
A
1040 mm (41 inches)
B
A
74 mm (3 inches)
C
A
364 mm (14 inches)
D
Practical tips
Trailer towing
Technical Data
239