Seat ALHAMBRA Owner's Manual page 337

Rear light, left
Unscrew the attachment screw
5.
screwdriver from the on-board tools
Extract the tail light from the bodywork by carefully pulling back-
6.
7. Pull the red strip on the connector and extract the connector.
8. Disassemble the tail light unit and place it on a flat, clean surface.
To change the bulb
To release the lamp holder, press on the attachment tabs
9.
page 334, fig. 209
10. Remove the lamp holder from the tail light unit.
11. Replace the faulty bulb with a new identical bulb.
Place the lamp holder in the tail light unit. The attachment tabs
12.
should audibly click into place.
Insert the connector and press the red attachment strip in so that
13.
the connector is locked into place.
Safety First
Rear light, right
A
page 334, fig. 208 using the
2
page 321. The bolt is
secured in its position.
wards.
A A
to in the direction of the arrow.
1 4
Operating instructions
Assembling the tail light units
Complete operations only in the sequence given:
Rear light, left
Carefully insert the tail light unit into the opening in the bodywork.
14. To do this, insert the upper tail light unit guide into the attachment
Tighten the white attachment screw using the screwdriver from the
15.
Ensure that the tail light unit has been correctly fitted and is firmly
16.
A
Replace the cap and rotate it
1
17.
90° in the opposite direction of
the arrow.
18. Close the storage compartment.
19. Close the tailgate
Practical tips
If and when
Rear light, right
ring.
on-board tools.
secured.
Move the 12 V socket support
upwards gently until it is correctly
closed.
page 88.
Technical Data
335