Seat ALHAMBRA Owner's Manual page 107

"Coming Home" Necessary operations
– Switch off the ignition.
– Briefly flash the headlights for approximately one sec-
To switch sys- ond
tem on: The "Coming home" lighting comes on when the driver's
door is opened. The delay in switching off the headlights
is counted from when the last door or tailgate is closed.
– Automatically at the end of the delay period.
– Automatically, if 30 seconds after coming on, a vehicle
To switch sys-
door or tailgate remains open.
tem off:
– If the light switch is turned to position .
– If the ignition is switched on.
"Leaving home" Necessary operations
– Unlock the vehicle when the light switch is in position
To switch sys-
tem on:
and the photo sensor detects darkness.
– Automatically, at the end of the delay period.
– When the vehicle is locked.
To switch sys-
tem off:
– When the light switch is turned to position .
– When the ignition is switched on.
Lighting around the exterior mirrors
The lighting around the exterior mirrors illuminates the door area on entering
and leaving the vehicles. It comes on when the vehicle is unlocked, when the
vehicle door is opened and when the "Coming home" or "Leaving home"
function is switched on. If the equipment includes the light sensor, the
lighting around the exterior mirrors only comes on when it is dark.
Note
The time taken for the headlights to go off can be changed in the menu
Lights & Visibility and the function can be switched on or off
Safety First
page 100.
Operating instructions
When the "Coming home" function is on, if the vehicle door is opened
there is no audible warning signal to advise that the light is still on.
Headlight range control, instrument and switch lighting
A
Instrument and switch lighting
1
When the headlights are switched on, the brightness of the instruments and
switch lighting can be regulated to suit your requirements by turning the
switch fig. 63
A
Headlight range control
2
The headlight range control
of the headlight beam and the vehicle load status. This offers the driver
optimum visibility and the headlights do not dazzle oncoming drivers
The headlights can only be adjusted when the dipped beam is switched on.
To reset, turn switch
page 65.
Practical tips
A
.
1
A
fig. 63 is modified according to the value
2
A
fig. 63 :
2
Technical Data
Lights and visibility 105
Fig. 63 Next to the
steering wheel: instru-
ment and switch lighting
A
control and headlight
1
A
range control .
2
.