Seat ALHAMBRA Owner's Manual page 19

WARNING (continued)
Always have damaged seatbelts replaced immediately by seat belts
approved for the vehicle in question by SEAT. Seat belts which have been
worn in an accident and stretched must be replaced by a qualified work-
shop. Renewal may be necessary even if there is no apparent damage. The
belt anchorage should also be checked.
Never attempt to repair, modify or remove a seat belt yourself. All
repairs to seat belts, retractors and buckles must be carried out by a
specialist workshop.
Warning lamp
Safety First
Fig. 3 Warning lamp on
the instrument panel
Operating instructions
Lights up
or Possible cause
flashes
Driver's seat belt not fastened
or front passenger's seat belt
not fastened if the front pas-
senger's seat is occupied.
Objects on the front passen-
ger's seat.
Some control and warning lamps on the instrument panel will come on to
check certain functions when the ignition is switched on. They will switch off
after a few seconds.
A signal will be heard for a maximum of 90 seconds if the seat belts are not
fastened as the car drives off and reaches a speed of more than 25 km/h or if
the seat belts are unfastened while the vehicle is in motion. The seat belt
warning lamp will also flash.
Practical tips
Seat belts
Fig. 4 Example of seat
belt status display for the
rear seats (here, a 7-seat
vehicle) on the instrument
panel. above the second
row and below the third
row of seats.
Solution
Fasten seat belts!
Remove any objects from the
front passenger's seat and store
them safely.
Technical Data
17