Seat ALHAMBRA Owner's Manual page 333

To replace the xenon headlights bulb
There is no need to remove the headlight to replace bulbs.
Complete operations only in the sequence given:
Safety First
Fig. 202 In the engine
compartment: Turn signal
cover.
Fig. 203 Turn signal indi-
cator lamp holder
A
turning light .
2
Operating instructions
Turn signal indicators
Always take the checklist into account and take the necessary
1.
2.
Rotate the cover
3.
Rotate the lamp holder
fig. 203 to the left all the way
4.
and pull it out backwards with the
bulb.
Depending on the model, the bulb is removed directly from the lamp
5.
holder or it may need to be rotated and then removed.
6. Replace the faulty bulb with a new identical bulb.
Place the bulb holder in the head-
7. light and rotate to the right all the
way.
Rotate the cover
8.
Always seek the help of a specialist when changing the Xenon dipped beam
and full beam headlamps
Note
The illustrations show the left hand headlight. The structure of the right hand
A
and
1
side headlight is symmetric.
Practical tips
A
Cornering lights
1
actions page 328.
Open the bonnet page 276.
fig. 202 in the direction of the arrow and remove
it.
A
1
Press the wire clip downwards
and pull the lamp holder
fig. 203 out with the bulb.
Place the lamp holder in the
headlight and pull the wire clip
upwards until it clicks into place.
fig. 202 in the opposite direction to the arrow as
far as it will go.
in "Introduction" on page 327.
Technical Data
If and when 331
A
2
A
2