Seat ALHAMBRA Owner's Manual page 125

Switch the ignition on.
Press the required memory button.
Select reverse gear.
Adjust the front passenger exterior mirror so that you can see, for
example, the kerb area.
The new position of the mirror will be stored automatically and allocated
to the vehicle key that was used to unlock the vehicle.
Activating exterior mirror settings
With the driver's door open and the ignition turned off, push the memory
button of the corresponding door briefly.
ALTERNATIVELY: With the ignition switched on, hold in the corresponding
memory button until the stored position is reached.
To activate the memory function of the vehicle key
Important: a position must be stored in the memory.
Open the driver-side door.
Press and hold any memory button.
Within the following three seconds, push the button
vehicle on the vehicle key. A sound confirms the settings have been acti-
vated.
Adjusting the wing mirrors for driving and assigning driver seat settings to a
vehicle key
Activate the memory function of the vehicle key
Adjust the front seat and the exterior mirrors.
Lock the vehicle. The settings are assigned to the vehicle key.
To deactivate the memory function of the vehicle key
Important: a position must be stored in the memory.
Press and hold the
SET
Safety First
to open the
button.
Operating instructions
Within the following ten seconds, push the button
on the vehicle key. A sound confirms the settings have been deactivated.
Initialising the seat position memory
The position memory system must be initialised if, for example, the driver's
seat has been changed.
Initialisation deletes all memories and assignments for the seat with position
memory. The memory buttons can then be reprogrammed and the vehicle
keys re-assigned.
Open the driver's door and do not get into the vehicle.
Operate the seat settings from outside the vehicle.
Move the angle of the backrest completely forwards.
Release the control to set the angle and then press again until a sound is
heard.
Note
The front passenger exterior mirror automatically changes from the position
stored for reversing as soon as the vehicle moves forward at a speed of at
least 15 km/h or when the gear selection lever is changed to a position other
than R.
Practical tips
Seats and storage compartments
to open the vehicle
Technical Data
123