Seat ALHAMBRA Owner's Manual page 342

340 If and when
The vehicles should not touch. Otherwise, current may be allowed to flow
when the positive poles are connected.
Connect the clamps so they have good metal-to-metal contact with the termi-
nals.
If the engine fails to start straight-away, switch off the starter after about 10
seconds and try again after about a minute.
Complete operations only in the sequence given.
Jump lead terminal connections
Switch off the ignition of both vehicles
Likewise, open the battery cover in the engine compartment
or remove the positive pole cap from one side
page 339, fig. 212.
Connect one end of the red jump lead to the positive terminal
A
page 339, fig. 213
+
A
flat battery .
A
Connect the other end of the red jump lead to the positive terminal
the vehicle providing assistance
For vehicles without Start-Stop system: Connect one end of the black
jump lead to the negative terminal
page 339, fig. 213.
For vehicles with Start-Stop system: Connect one end of the black
jump lead to a suitable ground connection, a solid piece of metal in the
engine block, or to the engine block
Connect the other end of the black jump lead
nent connected to the engine block, or onto the engine block itself of the
vehicle with the flat battery however, connect it as far away as possible from
A
the battery .
A
Place the leads so that they cannot be caught by any moving parts in the
engine compartment.
3)
Vehicles whose battery is not located in the engine compartment
page 175.
3)
, in the direction of the arrow
A
or page 339, fig. 212 of the vehicle with the
+
A
.
B
A
in the vehicle providing assistance
-
page 339, fig. 214.
A
to a solid metal compo-
X
Switching on
Start the engine of the vehicle supplying current and let it run at idling
speed.
Start the engine of the car with the flat battery and wait two or three
minutes until the engine is "running smoothly".
Removing the jump leads
Before you remove the jump leads, switch off the headlights (if they are
switched on).
Turn on the heating and rear window heater in the vehicle with the flat
battery. This helps minimise voltage peaks which are generated when the
leads are disconnected.
page 289,
With the engines running, disconnect the leads in reverse order to
connection.
Close the battery cover, or replace the positive pole cap
WARNING
A
in
+
Incorrectly jump starting could cause the battery to explode resulting in
serious injury. Please observe the following rules to minimise the risk of a
A
battery explosion:
B
All work involving the vehicle battery and electrical system can cause
A
corrosion, fire and serious electric shocks. Always read and take into
X
account the safety warnings and standards before beginning work on the
battery page 289, "Vehicle battery".
Always protect your eyes with suitable working goggles and never lean
over the vehicle battery.
The jump leads must be connected in the correct order: first the positive
cable, then the negative cable.
Do not attach the negative cable to parts of the fuel system or to the
brake hose/pipe.
page 339.
3)
.