Seat ALHAMBRA Owner's Manual page 312

Hide thumbs Also See for ALHAMBRA:
Table of Contents

Advertisement

310
Wheels and tyres
The jack may be applied only at the jacking points shown (marks on chassis)
page 309, fig.
180. The mark indicates the jacking points below the
vehicle. The jacking points are on the ribs behind the front edges
Always use the relevant jacking point for the wheel to be changed
Raise the vehicle using only the designated jacking points.
Check list
For your own safety and that of other passengers, the following points should
be observed in the order given
1.
Select a suitable flat and firm surface for raising the vehicle.
2.
Switch off the engine, engage a gear (manual gearbox) or place the
selector lever in position P
parking brake
page 188.
3.
When towing a trailer: unhook the trailer from the towing vehicle and
park it correctly.
4.
Loosen the wheel bolts on the wheel to be changed
5.
Look below the vehicle for the jacking point
closest to the tyre which has to be changed.
fig.
:
page 179 and turn on the electronic
page 308.
page 309, fig. 180
6.
Raise the jack with the handle until it can be inserted below the jacking
point.
181.
7.
Ensure that the foot of the jack is firmly on the ground and that it is
.
placed immediately below the lifting point on the vehicle
8.
Straighten the jack and continue raising it using the handle until the claw
holds the vertical reinforcement beneath the vehicle
9.
Raise the vehicle until the wheel is clear of the ground.
WARNING
If the vehicle is not correctly raised, it could fall off the jack causing serious
injury. Please observe the following rules to minimise the risk of injury:
You should only use a jack approved by SEAT for your vehicle. Other
jacks, even those approved for other SEAT models, might slip out of place.
The ground should be firm and flat. If the ground is sloped or soft then
the vehicle could slip and fall off the jack. If necessary, support the jack on
a wide solid base.
If the ground is slippery (for example, on tiles), place a non-slip surface
(for example a floor mat) beneath the jack to avoid slipping.
A
Fig. 181
: jack mounted on the left front part of the
A
A
vehicle
: jack mounted on the left rear part of the
B
vehicle.
fig.
fig.
181.
181.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents