Seat ALHAMBRA Owner's Manual page 345

Fitting the front tow ring
The location for the removable tow ring is on the right-hand side of the front
bumper fig. 215.
The towing eye should always be kept in the vehicle.
Note the instructions for towing
To fit the tow ring
Take the tow ring from the vehicle tool kit
Press on the upper cover and carefully remove it forwards. Allow the cover
to hang.
Screw in the tow ring into its position anticlockwise as far as it will go
fig. 215 . Use a suitable tool to firmly tighten the tow ring in its loca-
tion.
After towing, remove the tow ring by turning it clockwise and put the cover
back in place.
Safety First
Fig. 215 On the right-
hand side of the front
bumper: Screw in the
towing ring.
page 342.
page 321.
Operating instructions
Caution
The tow ring must always be completely and firmly tightened. Otherwise, it
could be released while towing and tow-starting.
Fitting the rear tow ring
The location for the removable tow ring is on the right-hand side of the rear
bumper fig. 216. For vehicles with a factory fitted trailer system, there is no
fitting behind the cover to insert the tow ring. For towing, fit and use the trailer
hitch page 233, .
Note the instructions for towing
Fitting the tow ring to the rear for vehicles without factory fitted tow hitch
Take the tow ring from the on-board tools
Press on the upper cover and carefully remove it back. This may require
some strength. Allow the cover to hang.
Practical tips
If and when
Fig. 216 On the rear
bumper, to the right hand
side: Tow ring in position.
page 342.
page 321.
Technical Data
343