Table of Contents
Advertisement
Rack/Local Switch
The Rack/Local switch on the top of the PhaseAdept Module determines whether the module is
controlled from its front panel local controls (Local Mode) or by the enclosure control processor or
dimming engine (Rack Mode).
Note:
The Rack/Local switch is set to Rack Mode by default.
Phase Adept Module Top View
Rack/Local Switch
Rack Mode
PhaseAdept Modules ship in Rack Mode by default. In Rack Mode the module is controlled by the
enclosure control processor or dimming engine. Rack Mode is supported in enclosures with CEM+ and
Rack Configuration
page 72
CEM3 control processors or DRd dimming engines. See
on
.
Local Mode
A PhaseAdept Module set to Local Mode is controlled by an internal dimming engine with manual
controls for setting min scale and forward/reverse phase selection. Local Mode is supported in all
Rack Configuration
page 72
enclosure types and is required in some rack types. See
on
.
PhaseAdept Dimmer
71
Advertisement
Table of Contents
Need help?
Do you have a question about the Sensor3 CEM3 and is the answer not in the manual?
Questions and answers