Led Error States - ETC Sensor3 CEM3 User Manual

Min Scale Dials
The minimum scale for each dimmer can be set while the module is powered on. To access the min
scale dials, remove the screw securing the dial and microUSB port cover with a #1 Phillips screwdriver.
Phase Adept Module Top View
See
switches. See the label on the front of the module or the table below for switch settings.
Dial Position
0
1
2
3
4
5
6
7
8
Note:
Forward/Reverse Phase Switches
To access forward or reverse phase for each circuit, remove the screw securing the cover over the
forward/reverse switch with a #1 Phillips screwdriver. See
Installed page 73
on
Forward/Reverse Phase Switches
ON
1 2
Note:

LED Error States

LED Behavior
Steady on
Slow blink
Fault
(1 per second)
Fast blink
(1 per half second)
74
page 71
on
Minimum
Scale
OFF
5%
10%
15%
20%
25%
30%
40%
50%
Both minimum scale dials are factory set to 0 (OFF) by default.
. See the label on the cover or the diagram below for switch settings.
• Switches: switch 1 controls the top circuit; switch 2 controls the
bottom circuit.
• Switch position: ON (up) is forward phase; OFF (down) is
reverse phase.
Both forward/reverse phase switches are factory set to OFF (down) by default, setting
both circuits to reverse phase.
Inrush current threshold exceeded or short circuit detected. See
Short Circuit Protection
Temperature threshold exceeded.
Voltage threshold exceeded. See
69
.
. Use a 2.4 mm flatblade screwdriver to adjust the rotary
Minimum Scale Dials
Bottom Dimmer
Minimum Scale Dial
Top Dimmer
Minimum Scale Dial
Phase Adept Module Front View with Covers
Status
page 69
on .
Voltage Spike Protection
MicroUSB Port
page
on
CEM3 User Manual