Quick Setup And Info - ETC Sensor3 CEM3 User Manual

Quick Setup and Info

General Notes: Select [Abort] on any screen to return to the home screen.
[Quick Setup] is shown on the home screen if the rack property
"Setup at Home" is set to Yes. See Rack in the Setup menu flow chart.
Rack #1 - CEM3 Rack Rack #1 - CEM3 Rack Quick Setup: Module
System OK System OK
Presets Active
10.101.101.101 Rack Type:
DMX A: Off DMX A: Off DMX B: Off DMX B: Off Module:
sACN: 1/1 sACN: 1/1
[Quick Setup] [Quick Setup] [Info] [Info] [Abort]
Quick Setup: Module
Rack Type:
Module:
[Abort]
Rack #1 - CEM3 Rack Rack #1 - CEM3 Rack Rack #1 - CEM3 Rack View/Clear Errors
System OK System OK
System OK
Fan Fail
Presets Active
10.101.101.101
DMX A: Off DMX A: Off DMX B: Off DMX B: Off DMX A: Off
sACN: 1/1 sACN: 1/1 sACN: 1/1
[Quick Setup] [Quick Setup] [Info] [Info] [Quick Setup]
48
Select Module Type
[Dimmer]
[Relay]
SR48 [Relay (ND)]
[Unchanged] [Thru Relay]
[Fluorescent]
[Low Wattage]
[Next] [Generic]
About Dimmer
Quick Setup: Circuit
SR48 Numbering:[Unchanged]
[Unchanged]
[Next] [Abort]
Quick Setup: Circuit
Numbering:[Unchanged]
[Abort]
Select an error
and press [Enter] to clear
Note:
it. If the error cannot
DMX B: Off
be cleared, it will stay
in the list
[Info]
Select Module
[D15]
[D15AF]
[D20J]
[D20AF]
[D20AFN]
[D20AFNJ]
[D20AFG]
1
Quick Setup: Circuit
Numbering: [Renumber]
Starting At: [1]
Balance: [3-phase]
Space: [1]
[Next] [Abort] [Next]
Quick Setup: DimDbl
Dimmer Double:
DMX Offset:
[Next]
sACN Offset:
[Abort]
Quick Setup: Patch
Patch:
Start at:
DMXA:
DMXB:
sACN:
[Abort]
Quick Setup: Patch
Patch:
DMXA:
DMXB:
sACN Universe:
sACN Address:
[Abort]
Quick Setup: Patch
Patch: [UniverseSplit]
DMXA:Ckt1
DMXB:Ckt -
sACN Universe:
sACN Address:
[Abort]
.
Module Types and Modules
displayed vary by rack type.
Note:
Modules with no configurable
settings (AFM, CC)
are not displayed.
[No]
[256]
This screen is shown for
Note:
SR or SP type racks only.
[10000]
[Next]
Quick Rack Setup
[Simple] Are you sure?
[1] This operation will
[Off] create a new config
[Off] and erase the rack's
[On] configuration.
[Next] [Abort]
[Independent]
[Off]
[Off]
[1]
[1]
[Next]
@ [Off]
Note:
Patch mode Universe Split
@ Off
is not available when
[1] dimmer doubling.
[1]
[Next]
CEM3 User Manual
[OK]