Loading CEM3 Software
You can upgrade your CEM3 software using the same methods as loading configurations (see above).
CEM3 software can be obtained by contacting ETC Technical Services (see
From USB Media
1:
Back up the rack configuration using the steps outlined in
2:
Navigate to [Setup]>File Operations>Upgrade from USB
appear.
3:
Use the scroll wheel to navigate the file structure to the desired configuration file (CEM3
software file names will end in ".bld") and press [Enter]. A confirmation screen will appear.
4:
Select Yes to continue, or select No to cancel the upgrade. The software upgrade process will
take several minutes.
From a Computer
To load a configuration from a computer on the system network, see
page 42
on
.
You can also use ETC UpdaterAtor software to upgrade your CEM3. UpdaterAtor can be downloaded
from the ETC website at etcconnect.com.
From Net3 Conductor or an FTP Server
Navigate to [Setup]>File Operations>Load from Server and choose the desired file from the list that
appears (CEM3 software file names end in ".bld"). See
page 36
or contact ETC Technical Services for assistance with setting up an FTP Server for use with
CEM3.
Common Tasks
page 2
Saving Configurations
.
The Software Upgrade screen will
Using the CEM3 Web Interface
Working with Net3 Conductor Over FTP
).
page 30
on
.
on
31
Need help?
Do you have a question about the Sensor3 CEM3 and is the answer not in the manual?