Rack Configuration; Configuring Local Mode - ETC Sensor3 CEM3 User Manual

Rack Configuration

Some possible rack configurations are listed below. Contact technical support with questions about
other rack configurations.
Control Processor
CEM3 (v1.7.0+)
CEM3
CEM+
CEM Classic/ECEM
MPE
CMd/CMEd
DRd Dimming Engine
Note:

Configuring Local Mode

With the Rack/Local switch set to Local Mode, the PhaseAdept module can be configured from its front
panel. See Rack/Local Switch
and forward/reverse phase switches, you must remove two covers. Remove the screw and cover on the
front panel to access the forward/reverse phase switches. Access the top of the module to remove the
screw and cover for the minimum scale dials and microUSB port. See
with Covers Installed
Phase Adept Module Front View with Covers Removed
and
72
Rack/Local
Switch
Setting
Rack Mode LED10
Local Mode D20
Local Mode D20
Rack Mode ELV10
Local Mode D20
Local Mode D20
Local Mode D20
Local Mode D20
Rack Mode ELV10
Older Unison DR enclosures may require rewiring in order to work with PhaseAdept
modules.
on page 71
page 73 Phase Adept Module Front View with Covers Installed
on ,
Module Configuration in Rack
120 V 230 V
ELED6
ED15
ED15
HELV5
ED15
ED15
ED15
EELV6
. In order to access the minimum scale dials, microUSB port,
page 73
on
277 V
AD20
AELV5
Phase Adept Module Top View
page 73
on
.
CEM3 User Manual
,