Boot Screen; Normal Operation; Rack Type Or Backplane Mismatch; Configuration File Conflict - ETC Sensor3 CEM3 User Manual

Boot Screen

Normal Operation

Rack Type or Backplane Mismatch

This boot screen is shown if either of the following occur:
• The rack type in the CEM3 configuration does not match the rack type detected from the
backplane and there is no communication with the backplane processor
• The version of the configuration saved in the backplane does not match the version of the CEM3
and the backplane cannot be read

Configuration File Conflict

This boot screen is shown if the CEM3 and the backplane have different configuration files that are
both valid for the detected rack type.
46
Rack #1 - CEM3 Rack
System OK
ETC CEM3
DMX A: Off DMX B: Off
sACN: 1/1
[Quick Setup] [Info]
Rack #1 - CEM3 Rack Initial Rack Setup
System OK Rack Number: [001]
First Circuit: [99999]
Model: [ESR48]
Module: DMX A: Off DMX B: Off [ED15AF]
sACN: 1/1 AF: [Enabled]
[Quick Setup] [Info] [Go]
Note:
Available model and module
types depend on rack voltage.
Rack #1 - CEM3 Rack Rack Change Detected
System OK The configuration in
this CEM3 does not
match the rack.
Note:
Switching to the rack DMX A: Off DMX B: Off
sACN: 1/1 config in 5s
[Use Rack Config]
[Quick Setup] [Abort] [Info]
Rack #1 - CEM3 Rack Rack Change Detected Rack #1 - CEM3 Rack Config Selection
System OK Would you like to use
System OK The configuration in
this CEM3 does not the configuration of
match the rack. the CEM3 or of the
DMX A: Off DMX B: Off DMX A: Off rack backplane?
Switching to the rack
sACN: 1/1
sACN: 1/1 config in 5s
[Use Rack Config] [Backplane Config]
[Quick Setup] [Abort] [Info] [Quick Setup]
Rack #1 - CEM3 Rack Config Selection
System OK Would you like to use
the configuration of
the CEM3 or of the
DMX A: Off rack backplane?
sACN: 1/1
[Backplane Config]
[Quick Setup] [Clear Configuration]
ETC CEM3
1.7.0
Reading Backplane
Rack #1 - CEM3 Rack Initial Rack Setup
System OK
Building Rack
Configuration
DMX A: Off Please Wait DMX B: Off
sACN: 1/1
[Quick Setup] [Info]
If you do
not select an action, the
seconds displayed will count
down toward zero and the
backplane configuration will
be used.
Shown if rack type in
backplane and CEM3
configuration files match.
Note:
DMX B: Off
Select [Backplane Config] or
[CEM3 Config] [Info]
backplane and config
[Clear Configuration] to
Note:
generate a new default config
DMX B: Off
[Info]
[CEM3 Config].
Shown if rack type in
do not match. Select
or select
[Backplane Config].
CEM3 User Manual