ETC CEM3 Setting Up

Setting up a loaner

Hide thumbs Also See for CEM3:

Download this manual

Setting Up a Loaner CEM3 Processor

Getting Started

Thank you for taking advantage of ETC's loaner program.

Once you've followed the instructions below, pack up your unit in the box the loaner came in. Please send only the items

on the repair order; unless instructed otherwise, do not send in any accessories, cables, or peripherals. If you do not

have the appropriate packing material,

Please ship to:

If you run into any issues while following the process outlined below,

CEM3 processors require a configuration to function.

Ensure that power to the rack is disconnected before removing any components. Failure to do so can

result in damage to your equipment or personal injury.

Check Functionality

There's a good chance that ETC Technical Services is ahead of the game with a CEM3! If we had a configuration on file

or were able to get enough information to build one, ETC may have loaded it to your loaner already. After powering

down the rack, simply remove your CEM3 by pulling down on the two tabs on either side and then pull it straight out of

https://support.etcconnect.com/ETC/Power_Controls/Sensor/Sensor3/Hardware/Setting_Up_a_Loaner_CEM3_Processor

contact ETC Technical

Services.

ETC, Inc

ATTN: RMA# <your RMA number>

3031 N Pleasant View Rd

Middleton, WI 53562

contact ETC Technical

Services.

Updated: Thu, 15 Aug 2024 13:33:33 GMT

Need help?

Do you have a question about the CEM3 and is the answer not in the manual?

Page 1 ETC may have loaded it to your loaner already. After powering down the rack, simply remove your CEM3 by pulling down on the two tabs on either side and then pull it straight out of https://support.etcconnect.com/ETC/Power_Controls/Sensor/Sensor3/Hardware/Setting_Up_a_Loaner_CEM3_Processor...
Page 2 Load from USB If the CEM3's ability to communicate with the backplane is compromised or there is no backup copy stored in the rack, this message may not appear. In this case, you can load the configuration from USB if you have a backup. Follow the...
Page 3 This setting can be found in [Setup] > [Rack] > [System Number]. Other Situations If you have a situation not described above, or you need help following these steps, please contact ETC Technical Services. https://support.etcconnect.com/ETC/Power_Controls/Sensor/Sensor3/Hardware/Setting_Up_a_Loaner_CEM3_Processor Updated: Thu, 15 Aug 2024 13:33:33 GMT...