Leveling (Side To Side) - Landoll 2130 Operator's Manual

4-10 LEVELING (SIDE TO SIDE)

4-10.1 Leveling the 2130 Wing Coulter Chisel
side-to-side involves leveling the wing frame
to the center frame. The unit should be level
side-to-side when operating in the field.
4-10.2 To level the unit, verify that all tires are
properly inflated.
folded, raise the unit to fully extend the lift
cylinders. Continue to hold the tractor lever
30-60 seconds to insure that the cylinders
are fully extended and the rephasing lift sys-
tem has been purged of air. Lower the unit
until the coulter points are approximately 1"
off the ground. On the center frame, mea-
sure the distance from the walking beam
spindle to the bottom side of the frame (See
Figure 4-7). Measure the same distance on
the wing frame. The wing frames are gener-
ally set to the same distance or slightly
higher than the center frame. Adjusting the
anchor at the base end of each wing lift cyl-
inder sets wing frame height (See Figure
4-8).
4-8
With the implement un-
Figure 4-7 Leveling from Side to Side