Landoll 2130 Operator's Manual page 67

4-5.5 To fold/unfold the 2130 Wing Coulter
Chisel, find a level area large enough to ac-
commodate the implement when it is fully un-
folded. The tractor should be stopped and
not moving with the unit fully raised.
move the transport lock pins from the mounts
and install them in the storage locations (See
Figures 4-4 and 4-5).
IMPORTANT
FAILURE TO REMOVE THE LOCK PINS
WHEN UNFOLDING WILL RESULT IN SERI-
OUS DAMAGE TO THE IMPLEMENT. BE
SURE OTHER PEOPLE AND PETS ARE A
SAFE DISTANCE AWAY.
4-5.6 Slowly engage the tractor lever and
fold/unfold the wing frames. When the wings
are unfolded, continue holding the tractor le-
ver to fully extend all fold cylinders. This will
allow the wings to fully flex in the field.
4-5.7 When the unit is fully folded, remove the
transport lock pins from the storage location
and install in the mounts provided on each
side of the machine.
WING STABILIZER
BRACKET
Re-
WING LOCK
PIN
1/4 X 3 ROLL
PIN
2130 foldlock1
Figure 4-4 Installed Position of Transport Locks
WING STABILIZER
BRACKET
WING LOCK
PIN
1/4 X 3 ROLL
PIN
2130foldlock2
Figure 4-5 Stored Position of Transport Locks
4-5