Troubleshooting Guide - Landoll 2130 Operator's Manual

TROUBLESHOOTING GUIDE

The Troubleshooting Guide, shown below, is included to help you quickly locate problems that can hap-
pen using your 2130 Wing Coulter Chisel. Follow all safety precautions stated in the previous sections when
making any adjustments to your machine.
PROBLEM
UNIT NOT PULLING EVEN
UNEVEN DEPTH
UNIT SIDE DRAFTS OR MOVES
SIDE TO SIDE
FRAMES NOT EVEN
SHANKS PLUGGING WITH RESIDUE
PROBABLE CAUSE:SOLUTION
Coulter gangs uneven depth: adjust depth/rephase
coulter gang cylinders. See "Hydraulic Coulter Gang
Lift System" on page 4-6.
Unit not level when under power in the field: level
unit front to rear. See "Leveling (Front To Rear)" on
page 4-6.
Excessive coulter gang depth or down pressure:
reduce coulter depth.
Tire pressure too low: check inflation.
Unit not level front to rear: adjust unit to be level.
See "Leveling (Front To Rear)" on page 4-6.
Wing frame and center frame not level: level wing
frames to center frame. See "Leveling (Side to Side)"
on page 4-8.
Lift cylinders not in phase: Fully extend lift
cylinders and hold hydraulic lever until all cylinders
are fully extended.
Fold cylinders not fully extended to allow wings
to flex: extend fold cylinders fully.
Lift wheels not carrying enough weight: adjust
depth stop and raise implement.
Unit not level front to rear: adjust unit to be level..
See "Leveling (Front To Rear)" on page 4-6.
Lift wheels not carrying enough weight: adjust
depth stop and raise implement
Wing frames and center frame not level to each
other: level wing frames to center frameSee
"Leveling (Side to Side)" on page 4-8.
Gauge wheels not set correctly or uneven: set
gauge wheels properly.
Unit not level: level machine. See "Leveling (Front
To Rear)" on page 4-6.
Coulters not cutting residue: adjust coulter depth.
Twisted shovels throwing soil wrong direction:
Install shovels as shown in Figures 2-1 - 2-14.
5
5-1