The Build; Construction Methods - Twisted Hobbys Veloxity Manual

CONSTRUCTION METHODS:

Building surface should be at least 2ft x 4ft and at. Weights or some small heavy objects will be handy for holding things in place
during the time glue is setting.
Welders glue is used for FOAM TO FOAM joints. Thin and Medium CA can be used on the PLASTIC TO FOAM and CARBON TO FOAM
joints. When using the Welders glue for a butt joint, apply a thin lm to each surface, allow to sit for approx ve minutes and
then assemble. Note that this method will create a nearly instant bond, so locate carefully when bringing the two pieces together. If
alignment is necessary or a slip joint, do not allow the glue to tack up, simple apply and join immediately, you will have several
minutes to locate the two parts before the glue sets up. In most cases the parts being glued can be handled with care in 30 minutes,
full cure is approx 24 hours.
The above picture items will be needed to nish the model.
A power combo (Twisted Hobbys' Combo pictured above),
and a battery. Note - the Welders and Receiver are NOT part
of the power combo, everything else shown is.
Rev: 2015.11.30.v01a

the build

Start the build by locating the two wings, the elevator and
the rudder. Fold back as shown and weigh them down for
about an hour to loosen up the hinge area. Now is also a
great time to setup your radio and to test that all your
electronics are functioning properly.
page 7