Twisted Hobbys Veloxity Manual page 8

Welders, Foam-Tac or CA can be used After the hinged parts have sat folded
Start from the top side and with the
as the primary method of joining the back for an hour or so, assembly can
3x1x250 spar. With the tip of the
parts. This Build will use Welders for all start. Locate the elevator, 5x1x250
Welders' nozzle, squeeze glue into the
joints unless called out otherwise. Two spar, 3x1x250 spar and 2 of the
pre-cut slot.
to three tubes of Welders are needed. 3x1x100 spars (or 1 of 3x1x200).
Make sure the spar is fully seated and Flip the elevator over to the bottom side
Lay the carbon spar into the slot.
ush as shown, wipe away any glue and ll the long slit with glue like was
that squished out. done on the top side.
page 8
Rev: 2015.11.30.v01a