Twisted Hobbys Veloxity Manual page 31

Once you have determined the general Under side showing one way to locate
With the Twisted Hobbys Power Combo,
location for all the components, stick the electronics.
the servos have extra long leads, so
them down with some low temp hot
extensions are not needed. Note the
glue.
location of the Crack Receiver.
Balance the props you will be using. Check all your directions and throws.
Add a 1.5" length of Blenderm to the
extreme ends of all the hinge lines. With the 100g TMW motor, a s12x6e With the included extensions you
Apply a thin patch of Welders under prop can be used. should be right at 100% Travel on the
where the Blenderm will go. Doing this Servo setup for all channels.
will strengthen the hinges
page 31
Rev: 2015.11.30.v01a