The Build - Twisted Hobbys Crack Yak-55 lite series Manual

CONSTRUCTION METHODS:
Building surface should be at least 2ft x 4ft and flat. Weights or some small heavy objects will be
handy for holding things in place during the time glue is setting.
Two types of glue are used for the build, Welders glue is use for most areas and CA for the horns
and guides. When using the Welders glue, apply When using the Welders glue, apply a thin film to each surface
When using the Welders glue, apply When using the Welders glue, apply
approx five approx approx approx five five minute five minutes s s s and then assemble minute minute
so locate carefully when bringing the two pieces together. If alignment is necessary while gluing
the two pieces together, do not allow the glue to tack up, simple apply and join immediately, you
will have several minutes to locate the two parts before the glue sets up. In most cases the parts
being glued can be handled with care in 30 minutes, full cure is approx 24 hours.
Carbon parts should be sanded and wiped clean prior to gluing. Take necessary precautions to
avoid breathing the carbon dust.
Rev: 2012.11.04.v004a

THE BUILD

THE BUILD THE BUILD THE BUILD
and then assemble. . . . Note that this method will create a nearly instant bond, and then assemble and then assemble
a thin film to each surface, allow to sit for
a thin film to each surface a thin film to each surface
Remove wing spar ribs that have the
oval holes from the wood kit. These are
for the inner spar slot where the spar is
two rods thick.
The center section, to the right in this
photo, is where the oval ribs and
double spar go.
, allow to sit for
, allow to sit for , allow to sit for
8