Twisted Hobbys Veloxity Manual page 24

Once you are happy with the tment, Join the two pieces together, make sure
Firmly press up and down the length of
apply glue to all surfaces, tabs and to feed the rudder servo wire thru the
the upper fuselage piece to ensure the
slots. correct side like in the test t.
two pieces are fully seated to each
other. Do this a couple times.
Wipe away any extra glue and check Locate the wood piece with the two
Put some tape around the nose so that
the front tabbed pieces are pull back along the length for squareness. As small slots and the tail skid as pictured
towards the motor mount a little. Don't with the bottom, it should naturally be above.
over do it... just enough so all the really close if not right. Tweak a little if
needed.
surface are rm against each other.
page 24
Rev: 2015.11.30.v01a