Twisted Hobbys Veloxity Manual page 9

Install the 5x1x250 spar into the slot.
Make sure it is ush and wipe away
any extra glue.
Install the 2 spars, again making sure
they are ush and wipe away any extra
glue. Set aside for now with some
weights to hold it at while the glue
dries.
Rev: 2015.11.30.v01a
Next is the two pieces that install as
pictured above. Some kits have 2 pieces
3x1x100, some have 1 piece 3x1x200. If
your kit has the 200mm long piece, cut
it in half.
Wings are joined together next. Note
that the bottom of the fuselage (side
with the servo cut outs) and the bottom
of the wings should be facing UP.
Fill both slits with Welders.
Note that there is a small round nub,
and a pre-cut slot. these should line
up. Test t to verify.
page 9