Twisted Hobbys Veloxity Manual page 17

Avoid glue in the area where the carbon Avoid glue in the area where the
With the main part of the assembly nice
landing gear struts will pass. elevator and rudder servos install.
and at on your work surface, press the
lower horizontal into all it's tabbed
areas, don't forget to put glue on the
motor mount tab and slot as well.
Once happy with the squareness and t While the previous step is drying,
Once it is all pressed together, wipe
away any extra glue and check for of the glue joint... weight everything attach the canopy to the upper vertical
squareness along the length of the down to ensure it will dry nice and at. fuselage section. Tack up Method can
fuselage. With the thickness of the foam be used for this step.
it should be pretty square on it's own.
page 17
Rev: 2015.11.30.v01a