Twisted Hobbys Veloxity Manual page 16

Install the rectangles like was done on Apply a medium coat of Welders to the
Squeeze some glue into each of the four
the top, and again making sure that under side of the LG Platform.
holes where the tabs will insert.
they engage the notches in the motor
mount
Apply some weights to the whole thing Once the previous step has dried, it is
Slide the LG Platform into position.
Applying enough pressure to ensure and let it set like this until the glue has time to attach the lower horizontal
that the glue is evenly dispersed. Wipe dried. Note a piece of tape is being used fuselage piece. Test t, then apply glue.
away any extra glue. to keep the front tabs of the nose in Note - avoid glue in the areas noted in
contact with the motor mount. the next two pictures.
page 16
Rev: 2015.11.30.v01a