Twisted Hobbys Veloxity Manual page 23

Locate the Rudder servo and the upper Again, cut a slit for the servo tang. For
Put a little hot glue on the edges of the
vertical fuselage section. this servo, only the rear tang needs a
cut out.
slit. Test t and remove.
Test t the top fuselage section. Make Also look to make sure all the tabs of
Install the servo... quickly, so that it is
ush with the near surface shown. sure and feed the rudder servo lead the fuselage are able to fully engage,
thru to the same side as was done with especially around the servo area in the
the elevator servo lead. back, and the motor mount area at the
nose of the aircraft.
page 23
Rev: 2015.11.30.v01a